Cleaning a MIG liner
On 8/9/2017 3:06 PM, Gunner Asch wrote:
On Wed, 9 Aug 2017 14:02:47 -0500, Terry Coombs
wrote:
I have one that's not feeding well , and wonder if it can - and
should - be cleaned . I have a new one on hand , but it's sized for
.035-.045 wire , and I usually use .025 solid . I have .035 flux core
loaded right now , but that was for an outside job that was blowing my
shield gas away and I'd much prefer to go back to solid - I also have
some .030 on hand but haven't yet tried it .
--
Snag
They can be cleaned..assuming its actually dirty enough to be an
issue. Most often..they have a kink in the liner somewhere.
Clean em by spoozing kerosene through the liner with compressed air,
after giving them a bit of a soak in a coffee can filled with kerosene
(or diesel etc etc)
No kinks , I have it out of the lead . I was thinking maybe a
kerosene soak as you suggested . Per your post above , it's not rusty in
the liner/lead/gun , it's the roll of wire inside the machine that has
some surface rust . It doesn't help that this machine lives on the lower
level of the cart I modified to carry the TIG setup . And sometimes when
it rains really really heavy a little water comes in under the door .
--
Snag
|