DIYbanter - View Single Post

Terry Coombs[_2_]

On 7/20/2017 10:52 PM, wrote:
On Thu, 20 Jul 2017 23:04:55 -0400, wrote:

On Thu, 20 Jul 2017 21:50:48 -0500, Terry Coombs
wrote:

It's an Aspire 7540-1317 laptop , and it belongs to my daughter .
They got it in a storage bay auction , and it apparently was used as a
terminal - no OS . I had to initialize the hdd , but it won't access the
BIOS/setup screen .

It pops up an error screen as follows :

Broadcom UNDI PXE 2.1 v11.4.1 followed by a copyright etc

then :

Base Code PXE 2.1 v1.1.0

PXE E61 media test failure check cable

PXE-MOF exiting broadcomPXE ROM

OS not found

I want to install a copy of Win7 Pro 64 bit so my 2 youngest grand
daughters can use it for their school work , any help will be appreciated .

BTW , they also got in that auction a Netgear ProSafe 8 port gigabit
network switch model GS108 and a uverse WAP model VEN501-AT which both
followed me home . They had no use for these ... and I'm thinking the
switch will work for my home network wiring , the WAP will be used to
enhance the wireless link to my shop . Also included in today's haul was
a 12V/3 amp power supply that will replace the burned out original
supply for my buried wire dog containment fence system . SCORE !

--

Snag
It has been a while since I screwed with an Acer but I think F2 gets
you to BIOS. Then turn off boot on LAN and be sure the CD is in the
boot sequence. On the BIOS screen you may be best to just reset to
factory defaults. It might even be worth pulling the CMOS battery and
using the reset jumper if all else fails.
A lot of these "medialess" clients turn off a lot of stuff you will
want, to keep people from loading their own software.
Your W/7 should have disk tools to prep the hard drive and rock on.
What's wrong with using the factory reset?

Here are the standard Acer Factory Recovery Instructions
1. Power on the machine

2. At the white ACER BIOS screen, hold the €œAlt€ key and press the
€œF10€ key simultaneously to start Acer eRecovery

3. Once eRecovery has loaded, click €œRestore to Factory Default
Settings€

4. Click €œOK€ to continue

5. From here, the eRecovery process will update all the data on the C:
drive and restore the original factory installation with no user
accounts.

6. Once eRecovery has run, press €œOK€ to reboot.

It might take a couple hours - I just redid a Veriton VM4630 this
afternoon (unknown user password issue)

Clare , does this assume there is an OS on the hard drive ? This hdd
was wiped when I checked - I pulled the hdd and hooked it up to another
comp to check for files - , it hadn't even been initialized or formatted
and it's not the original 320 , it's a 250 . I tried hitting F2 when the
initial acer splash screen comes up , nothing happens at all except that
it goes to the error message screen I posted above . I just tried
alt/F10 , same results . If I could get to the BIOS screen I'd be home
free ...

--

Snag