On 7/6/2017 8:41 PM, dpb wrote:
On 07/06/2017 4:01 PM, -MIKE- wrote:
On 7/6/17 3:37 PM, dpb wrote:
On 07/06/2017 11:17 AM, -MIKE- wrote:
...

... or your table saw needs trued up. The blade
trunnions need adjusted so the blade is be perfectly parallel to the
miter slots. ...

_Most_ saws will adjust the table to the trunnions, not vice versa...


--

Thank you, Semantics Nazi.


You're welcome...

In general the trunnions are the "immovable object". There are some
that _are_ vice versa, just not the most common so if OP were going to
do something figure it's the better bet...

--


Kinda hard to say there which is most common for adjustment.

IIRC contractor saws mount the trunion to the table and you loosen the
trunion and move the top.

Cabinet saws tend to have the trunion mounted to the cabinet and the top
is mounted to the cabinet.

Just saying. ;~)