On Sat, 24 Jun 2017 23:13:21 -0400, JBL wrote:

I am attempting to make a few "dovetails" which are brackets used to
attach a telescope to a telescope mount. If purchased outright, for the
kind of dovetails I need, the expense is beyond my budget. I recently
acquired some 1/2" aluminum sheet/ bar. The dovetail needs to be 1.75"
wide at the base, with the sides cut at a 15 degree angle. Length can
vary a bit, but usually about 12-14". My plan was to make at least 3
for the various telescopes I have.

I thought I'd be able to get away with an old circular table saw I had.
Last week, I made some 1/4" thick dovetails of a slightly different
design using my table saw fitted with a plywood blade. This went well,
but when I tried to make these thicker 1/2" dovetails today, I ended up
burning out my saw.

Ideas for a cheap way to make these dovetails would be welcome. I've
been watching Craigslist for another circular to replace the burned out
one, but I don't think it's the best tool for this job without a $30
plus blade made to cut metal and even then I'm not sure it will do it.

Thanks in advance for your help,
John
2 words. Band Saw.