On Thursday, June 22, 2017 at 6:49:36 PM UTC-4, rickman wrote:
John-Del wrote on 6/22/2017 4:15 PM:
On Thursday, June 22, 2017 at 3:48:13 PM UTC-4, rickman wrote:
frank wrote on 6/22/2017 7:47 AM:
Hi,
I already know the answer but we never know if anyone out there can make
miracles
I've been given a dead USB drive, in my linux laptop is identified as usb
storage device but it fails to read (probably) the capacity and the usb stack
keeps on resetting the device.
It's not possible to open it, looks like a small solid plastick stick with
metal tabs embedded on one side. It's just a bit longer than the typical
usb slot.
I tried heating and freezing it, just in case it was some temperature
sensitive fault, but behaviour never changed.
I don't think there's a way to expose the actual NAND-flash chip and read
it separately, but I'm asking the expert here
Did anyone ever found a way to open (or otherwise read) these little
data killer devices?

Just to be sure, you are talking about a USB Flash drive, right? I've yet
to find one I couldn't open. It would cost them extra money to make them
hard to open, solid plastic.


A good buddy of mine had some data and pictures on a flash drive that he could no longer read on his computer or any recovery software. So I opened it up looking for bad solder on the chip or a problem with the USB connector. Sure, the plastic outer case opened up easily enough but there was nothing inside. That's right, nothing.. Other than a two piece outer plastic case, the drive was a USB connector soldered to a multi-layer board with no external components on it. Whatever it used for a chip was embedded inside the PC layer.

Was there a black blob on the board? That would be epoxy covering the die
mounted to the board.

Absolutely not. I know what an IC printed on a PC and covered with epoxy looks like (most modern consumer electronics remotes have them).

This was a multi layer board with no exposed lands save for the USB connections. The rest of the board was green mask with no place for any parts to be soldered to. If he still has it I'll take a pic and upload it.