Thread
:
Routing question
View Single Post
#
11
Posted to rec.woodworking
Markem[_2_]
external usenet poster
Posts: 1,043
Routing question
On Fri, 28 Apr 2017 20:18:44 GMT,
(Scott Lurndal)
wrote:
Markem writes:
On Fri, 28 Apr 2017 08:11:58 -0700 (PDT), Ivan Vegvary
wrote:
Markem, use a roundover bit riding on what surface?
Using a plane soumds easiest. Did not think of that.
The 3/4 " left???
Plane and sanding vs router probably about the same amount time
invested.
I think you haven't visualized the problem sufficiently. A router
cannot acomplish Ivan's task.
A _______ B
/ \
/ \
| |
| |
-------------
End-on view of rail.
Ivan wishes to soften the corners A & B. Note that the slope
will be much shallower than the ASCII graphics above.
With the router in a table setup easily accomplished, I have done it.
Reply With Quote
Markem[_2_]
View Public Profile
Find all posts by Markem[_2_]