On Friday, April 28, 2017 at 8:48:20 AM UTC-5, Ivan Vegvary wrote:
Making railings out of 2x6 stock, 122 in long. The center will be dadoed for the pickets. The flat faces will have slopes near the edges created by table saw.
Is there any way to slightly round off the corner where the sloping top face meets the remaining (about 3/4 in.) vertical edge. Other than sand paper.
Think homemade threshold where the slight top slope meets the edge.
Thank you!

Grind a scraper profile using an old saw blade (either handsaw blade or circular saw blade) and scrape the profile? Possibly, form/grind a profiled blade (iron) that fits into a hand plane?

Sonny