On 2017-03-21, Bob Engelhardt wrote:
Phil, Eric, & DoN -- thanks. I'm curious enough to get the drill I need
(#16 for 10-32) & try it.
My lookup shows 4.4mm (usually metric sizes for roll taps for
imperial screws. That works out to 0.1732", while the #16 is 0.1770" so
the thread will be a bit poorly formed.
Good Luck,
DoN.
--
Remove oil spill source from e-mail
Email: | (KV4PH) Voice (all times): (703) 938-4564
(too) near Washington D.C. |
http://www.d-and-d.com/dnichols/DoN.html
--- Black Holes are where God is dividing by zero ---