MM wrote:
Does the puller shown on the right in this Screwfix product look like
it's suitable to remove the flywheel on an old Suffolk Punch 35S
lawnmower engine?
http://www.screwfix.com/p/bearing-se...r-puller/19315

MM


Hmm, don't think so.

If it looks like this
http://www.oldlawnmowerclub.co.uk/si...lk%20Punch.pdf
then I would hazard a guess that once you've removed the recoil starter and
pawl sub-assembly you might be able to screw bolts back into the two holes
in the flywheel on either side of the central left hand thread nut (once
you've removed it of course) through a short bar across the end of the
crankshaft. This should "push" the flywheel off the crankshaft.

You could even re-use the pawl hub sub-assembly (part 123) with something
to block the central hole packed behind it.

Tim