On Fri, 3 Feb 2017 22:05:48 -0000, "Benderthe.evilrobot"
wrote:


True. But the reason to replace them ALL is that if you only replace the
one(s) causing a problem, another will fail later, then another still
later. It is much easier to do them all at once than to have to repair
the same unit over and over as they fail one after another. Been there,
done that.

So have I.


I can totally understand what you are saying. However, I am not so sure
about whether I would want to replace all of them in certain parts of a
radio or tv. Here are my thoughts on this.

Lets take my Hallicrafters SX-99 (which I paid for but dont have yet).
That radio is 62 years old. (made in 1955). The seller said it works
fine, (and I was sent a video of it working. I did detect a very slight
hum. (But the video's audio is not the greatest).

So, as soon as I get it and play around with it, I will replace the
electrolytics in the power supply and any other 'lytics (if there are
others). Even if there is no hum, I'd replace them, just based on age.

However, this is a working radio. I ask myself if I really want to
replace all the other (small) caps. [Then I say to myself.... if it
works, dont fix it].

But, I know there are caps in specific circuits more likely to fail,
than in other circuits. Those would be caps connected to the high plate
voltages, especially at the audio output tubes and in the power supply.
I also know that if those short out, they can damage other parts, such
as tubes, resistors, and more. So, I would likely consider replacing
those. I might even consider replacing ALL the caps in the power supply,
and all audio stages, and feel safe doing that, since those caps are not
real critical as far as affecting the overall performance of the radio,
even if the new caps are a little different in their capacitance.

Where I do NOT feel comfortable changing them, are in all RF and IF
stages. The reason is that I know that a cap/coil circuit plays a big
part in the inductance, which affects the radio alignment. I am not
equipped to align the radio coils, and would prefer to leave them alone,
as long as the radio is getting good reception.

I also know that those RF and IF stages do not operate on as high
voltages as do the audio output stages. So, once again, I ask myself,
"Do I really want to risk throwing this radio out of alignment, when
it's working fine, and knowing those caps are not as likely to fail".

I answer myself "Probably not".... (As long as the radio is working
well, dont screw up a good thing.... Then too, if the caps in those
circuits are .05 or .003, I WANT a .05, not a .047. (And it seems that
..05 is no longer made).

So, if I'm satisfied with the performance of this radio, I will replace
the 'lytics regardless. I may also replace all caps AFTER the volume
control, as well as all caps in the power supply. But I will likely NOT
touch any caps in the RF and IF stages.

That's my thinking on all of this right now. Not just for this radio,
but anything..... Now, if it were simply an audio amplifier, I'd likely
replace all the caps, because audio is not all that critical.