On Sat, 13 Dec 2003 22:00:09 +0000, TonyK wrote:


"Ed Sirett" wrote in message
news
On Sat, 13 Dec 2003 12:51:33 +0000, derek wrote:

On 12 Dec 2003 13:32:15 -0800, (lioneluk) wrote:


There is one place I do work on with these. Every new tenant has to find
your that they must not be covered. There are warnings on the units.
The landlord stresses the importance but every one of them has to find out
that if you cover them then they switch off and need to be manually reset.


Does this mean you shouldn;t use those "nice" MDF radiator covers over them?
I have several in 100% original victorian rooms which I need / would like to
hide.

The issue is that anything that resticts the flow rate through the units
increases the temperature of the air emerging from the top of the unit.
If the unit were a fan or convector heater then likely a safety cutout
would trip and the temperature would reduce directly.

With storage heaters the trip will prevent them reheating the following
night, the bricks inside are probably still at 300C or more.

MDF covers will probably not affect the overall heat output but it will
mean that the air emerging is at a higher temperature. The manufacturers
may have a view on the matter - although they are likely to err on the
side of caution. It might also cause them the cut off to trip.



--
Ed Sirett - Property maintainer and registered gas fitter.
The FAQ for uk.diy is at www.diyfaq.org.uk
Gas fitting FAQ http://www.makewrite.demon.co.uk/GasFitting.html
Sealed CH FAQ http://www.makewrite.demon.co.uk/SealedCH.html