On Sat, 3 Dec 2016 08:41:13 -0800 (PST), Steve
wrote:

On Saturday, December 3, 2016 at 11:21:40 AM UTC-5, Steve wrote:
On Saturday, December 3, 2016 at 11:17:00 AM UTC-5, woodchucker wrote:
On 12/3/2016 11:05 AM, Steve wrote:
Hey, all-- I could use your help.

I'm running a Shop Fox 1HP Dust collector on 240v. 60 Hz; only 1HP. Runs like a dream.

I picked up the PSI Long Ranger III DC Remote system. 220V. It's rated for 2&1/2 HP; 220V, 60 Hz. I'm running 240V; 60 Hz; only 1HP. I programmed the remote, plugged the Remote switch into the Outlet, and the DC into the switch. I turned my paddle switch on.

I hit the power button on my remote, I heard a click inside the box...

... but nothing from the Collector.

Click on, Click off. No air movement. Paddle is ON.

I unplugged the DC, and plugged it direct into my outlet; ran like a dream, as usual.

I figured the switch was bad. I grabbed my voltage pen tester, turned everything on, and it reads hot all the way to the DC Motor. I hit the remote off; tester went off. remote off, no current. remote on, there's current.

The switch is working, the paddle is on, it's hot, and the remote works, but it's not firing the DC. What in heck is going on here?

Is it possible that the rating between the 220V of my switch and the 240v of the DC is really stopping this thing from going? My ignorant understanding is that 220v & 240v are widely interchangable.

Any ideas? Thanks in advance.


if you have a meter, attach the meter to the long ranger receiver.
You should be getting 220 or 240 in the output. perhaps you are only
getting one leg (120v) through, meaning that the long ranger is only
wired for 120... if that's the case call them and find out what to do.

--
Jeff

Thanks-- Great idea. I'll hit it with the tester. It IS a 220V receiver/switch... but yes, anything can go wrong in the wiring. Thanks again, Jeff!

you are correct, sir-- Pos-neg read nothing, but pos-ground read 120. Probably as simple as opening it up & reconnecting a lead... but I don't think I'll be taking any chances with this one. Back it goes for a new model! Thank you again.

Hot to ground should read 120V. If it's a 240V supply, there should
be *two* hots, each reading 120V to ground and it should read 240V
hot-to-hot. If it reads 120V on both hot-to-grounds, and 0V between
the two hots, then your 220V circuit is wired improperly. You're not
connected to both sides of the mains. It's probably a miswire in the
breaker panel. The two hots should come from adjacent breaker slots
in the panel (with a double throw breaker). This all assumes that
your house has 240V available in the box.