Garage Opener Install - limited length from wall to beam
I saw a show that had a motor mounted to the wall instead of the ceiling. It
went on the center of the header on the same wall as the door. Looked pretty
cool.
HTH
rik
--
Padded room with a view
RWC3
"Cox SMTP central" wrote in message
...
Does anyone have a solution to center mount a garage opener for a 17' x 7'
garage door where the distance from the front wall of the garage is 8' -
4"
from a steel ceiling beam the runs the width of the garage? The garage
door
company has used a side mount chain drive opener for the past 10 years
since
the house was built and I have the following recurring problems with this
type of setup.
- Side mount pulls on door unevenly and causes problem with
adjustment.
- Garage will only open within 10" of door opening because not enough
pull clearance.
The door company has indicated going to a gear drive opener and still
having
it side mounted will improve the pull by about 6 inches, but I would
prefer
to get the opener to the center of the door. I have been told that it is
not a good idea to cut into the beam. Any ideas - any new openers out
there?
--
Mike Krzywicki
|