Art, you are exactly right. This is why I ask prior to proceeding. I was
hoping it was a simple procedure and
could save a few dollars. Thanx for the response guys!


"Art" wrote in message
...
Also, do you have the necessary training to do the registration
adjustments
once you have it up and running again?? Question, you being an
electrician,
will you allow a computer or tele technician to wire your home, or
business?? That is unless they have proved they are totally competent in
doing so??
IMHO!! You get paid for the abilities for which you have been trained
and
show competency and experience in doing it correctly. Why don't you have
the
same respect for those who do the repairs on these infernal Consumer
Electronic Products? The price quoted is moderately fair for the repairs
on
your product.
"David" wrote in message
om...
It is not exactly a matter of putting in x,y and/or z part in a Sony
SMPS. After the obvious failed parts are replaced, certain steps MUST
be performed analyzing the regulation and waveforms of the power
supply to ensure that it will not blow up again. Then there is the
good possibility of other failures in the set that could have caused
the power supply problem.

If you have experience repairing switch mode power supplies to the
component level and all the required equipment, then you can have a go
at it, otherwise best left to a trained technician.

David

"SNIPER" wrote in message
news:gFSNc.114234$Rf.46514@edtnps84...
Apparently VERY common conversion blah blah power supply problem with
older
Sony Rear Projection TVs. Where can I get the part and how easy is it
to
put
in? The repair shop quoted $250-$350 cdn, but I'm an electrician and
would
like to know if I can do it myself.