I'll start looking around in that area. I was hoping for an easier
repair. I have another working receiver that I was thinking about
swaping boards with but I'm afraid I'll end up with two non working
receivers.

david


In article ,
"Mark D. Zacharias" wrote:

That's a REALLY unusual one. Might need factory service. Denon's service in
New Jersey isn't too expensive, really. Might run 125.00 or so plus freight.

I am an authorized Denon servicer, but I might shy away from this one, not
wanting to get bogged down chasing data, chip enable, clock lines etc. Does
sound like your problem is in this area though, a data line held low or some
such.

Mark Z.

--
Please reply only to Group. I regret this is necessary. Viruses and spam
have rendered my regular e-mail address useless.


"David Black" wrote in message
...
Hi,

I'm currently at lost as to what's wrong with my Denon AVR3300 receiver
and would be grateful for some assistance.
The receiver powers up and only somewhat works using the tuner volume
is very low. As soon as you switch to another source(CD, DVD, etc..)
the receiver has no output, even when going back to the tuner mode. The
receiver CPU must be reset to get the tuner to function again. Also, the
receiver does the same thing if you switch output modes(Dolby Digital,
Prologic, etc..) You again must reset the CPU to get any volume using
the tuner.


Has anyone ever seen this tyoe of problem before?


Thanks
david

--
--
David Black



--
--
David Black