Whatever you do, do not take that tv to the "repair shop" that you talked
with. There is no way they can determine that the picture tube is bad
without doing proper diagnosis. From your description it does NOT sound
like a picture tube problem.

You need to take the tv into a reputable and good shop for proper diagnosis
and repair. Given the description of the symptoms I would start by checking
the vertical circuit for intermittent solder connections or weak capacitors,
and then check for other common solder connection problems.

Typical repair if you take the tv into a reputable shop around here varies
between $90 and $125 total for 90% of the repairs on that size of tv set.

David

"BR" wrote in message
om...
I have a Sony KV-32S40, which I purchased in December of 1998. I have
not experienced any problems with it until today. I turned the TV on
today and everything was working fine as usual. After about 3-5
minutes the screen turned black but I still had audio. I turned the
TV off for a couple of minutes and turned it back on. It appeared to
be working fine until about 5 minutes later it did the same thing.
The screen just turned black. I turned the channels to make sure that
it wasn't the channel and turned on a different TV in the house to
make sure that it wasn't the cable. I let the TV set all day before I
tried turning it on again. After about a minute, the screen started
getting a bunch of lines in it and the picture appeared to be
shrinking from the bottom of the screen to the top of the screen.
Then the screen went black again. I again let the TV set for a little
while and tried it again. Now I don't even get a picture when the TV
comes on. I still have audio and can even switch channels, but there
is no picture. The red light on the front of the TV that says
"Standby/Timer" just keeps flashing. I didn't hear any noises when
the picture was going out. I talked to a repair shop today and they
said that the picture tube is probably bad and that it would cost more
to fix it than the TV is worth. I feel that I am a technical person
but I have never worked on a TV before. Does anyone know what this
sounds like or have any suggestions?