On Sun, 09 Oct 2016 08:23:49 -0500, "Lloyd E. Sponenburgh"
lloydspinsidemindspring.com wrote:
fired this volley in
:
I THINK he was talking about remoting the speed pot on the VFD. A
relatively simple 3 conductor cable on the "voltage devider".
Possible for sure, but a bit of a pain.
I never read any indications that he was talking about multi-phase
motors. OF COURSE it can be done that way, but all the discussion here
was about chopper-controlled single-phase induction motors.
I said VFD...and most VFDs can be remoted up to 500 feet, particularly
if using the 0-10 analog input for speed control. RS-485 will work
even farther.
That sort doesn't particularly like that sort of control _anyway_, unless
they were designed for high-slip operation (like, say, ceiling fan
motors).
But, again: A properly designed ball mill requires NO speed control over
a fairly wide range of jar sizes.
LLoyd
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus