Taxed and Spent formulated the question :
On 10/7/2016 5:09 PM, Stormin' Norman wrote:
On Fri, 7 Oct 2016 16:55:52 -0700, Taxed and Spent
wrote:

On 10/7/2016 4:23 PM, Stormin' Norman wrote:
On Fri, 7 Oct 2016 15:49:54 -0700, Taxed and Spent
wrote:

On 10/7/2016 3:40 PM, Stormin' Norman wrote:
On Fri, 7 Oct 2016 14:15:30 -0700, Taxed and Spent
wrote:

On 10/7/2016 2:11 PM, dpb wrote:
On 10/07/2016 3:29 PM, Taxed and Spent wrote:
I have a dough sheeter, which has two adjustable rollers for
establishing the thickness of a sheet of dough. There are no
measurement
indicators on the machine, so I am looking for a gauge to jam in
between
the rollers to measure their separation, i.e. the thickness of the
resulting dough sheet.
...

I'm presuming these aren't precision measurements nor particularly
thin...what about a few plexiglass shims or the like? I'd think
1/32"
would be more than enough discrimination...what's the desired range?


zero to 0.25 inches. I haven't figured out exactly what I want to go
construct anything yet, but feeler gauges might be a good start
(though
perhaps a clumsy start, if I need to add a couple together).

Take a look at this set of long feeler gauges.

http://amzn.to/2cXQEnG


yikes - expensive. Actually regular feeler gauges will be long enough,
and if I combine two, three, or four thicknesses I can get most
anything. if I zero in on a particular thickness that is the cat's
meow, I can make a dedicated gauge from wood, plastic, etc.

The same link has shorter gauges for much less. It sounded like you
were using these for an industrial application.


oooh! this is what I was thinking of!

https://www.amazon.com/Uxcell-Metric...feeler%2Bgauge

That should give you a relative measurement but probably not an
accurate measurement of the gap between two cylindrical rollers. I
think feeler gauges would be a better choice.

Is this for a commercial / industrial application or is this for home
use? If home use, then I doubt it would make a big difference.


home use, with a dough sheeter. This will be close enough - repeatably is
more important than precision.

That's what precision is, ITYM it is more important than 'accuracy'.