On 08/20/2016 9:04 AM, dpb wrote:
....

... the stub spindle is
almost unheard of any longer for things like the coping cut on
window/door rails to allow the full-length tenon instead just the stub.

....


One of the currently available Amana sets; better than nothing altho w/
just 1/4" shank is a little puny for more than just the occasional door
or two. When needing to produce 20 or so, not so much...

http://www.toolstoday.com/p-5251-window-stile-rail-cutters.aspx

Couldn't find picture of the stub spindle for the LD or HD shaper
off-hand, here's a listing of the double-ended one for the old 43-355
that has good picture of the stub end...

http://www.ebay.com/itm/43-357-Delta-Double-Ended-Shaper-Spindle-for-43-355-NEW-/330549756791

--

---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus