Thread
:
Wow & Flutter Meters
View Single Post
#
9
Posted to sci.electronics.repair
JC[_6_]
external usenet poster
Posts: 69
Wow & Flutter Meters
On 7/21/2016 4:30 PM, Ralph Mowery wrote:
In article ,
says...
Couple of problems arose.
I need 3 test signals:
JIS (3KHz) 1% @ 4Hz
CCIR (3KHz) 1% @ 4Hz (Same as JIS? Am I missing something here?)
DIN (3.15KHz) 1% @ 4Hz
These should, according to the limited service info I have, produce a 1%
reading on the meter for each relevant setting (JIS, CCIR,DIN)
JIS was giving me 0.5% so I read up on the Adobe Audition settings and I
guess i needed mod by 60 hz, (+/-30Hz). That gave me 1% display with JIS
but then doubles up on the CCIR/DIN giving 2%
JIS is supposedly an effective mean reading, CCIR/DIN are Peak, but I'm
not making sense of these readings, any ideas?
Amplitude of the input signal has no effect as long as its large enough
to register.
TIA.
The JIS, CCIR, and DIN are standards set by different countries.
JIA Japan
CCIR Mainly countries of or were of the British Empire
DIN Germany
You probably will not be able to adjust for all 3 countries standars at
once.
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
This is the Leader LFM-3160, there is a switch for each JIS, CCIR, DIN.
Reply With Quote
JC[_6_]
View Public Profile
Find all posts by JC[_6_]