On 18/07/2016 13:22, Tim Watts wrote:
This is plasterboard ---
Is there any downside to using 2 sheets of 9.5mm on studwork walls (will
be skimmed) vs 1 sheet of 12.5mm?
I have relatively little wall to cover compared to ceilings and it would
simplify ordering and storing to work with one type.
And I could overlap all joints in the 1st sheet which seems like a bonus.
Just wondered if there were any major downsides?
GripIts only work on 9.5-15 mm plasterboard? I know that's almost
certainly not major but if you were planning to use dozens of them and
only found out later ...
--
Robin
reply-to address is (intended to be) valid