On Wed, 29 Jun 2016 19:44:21 -0500, "Lloyd E. Sponenburgh"
lloydspinsidemindspring.com wrote:
Gunner Asch fired this volley in
:
Soon as it cools off a bit, Ill go out and dig it out and see exactly
what it is. I had it on a 3/4 hp drill press but it sang so loudly
that it drove me nuts and replaced it with an older 1hp drive from
another manufacture.. I dont remember what it is, but Ill find out.
I'd be interested, because I'm going to re-fit this stupid machine. It
wouldn't work with the current control - being tied to some proprietary
Delta features - but would be fine (if it's big enough) for the Mach-3
installation I am planning to do.
Lloyd
Sorry Lloyd..its 3hp.
Ive been a huge fan of the PC3 vfds..they have been badged many
different ways...Yaskawa IRRC was the developer..and they are
really..really good drives.
http://www.ebay.com/itm/YASKAWA-5-HP...-/351771321721
Its a slightly updated PC3..so look at the photo and remember what
they look like. They often came badged as a Telemechanic(sp?) as well
as Magnatech and EMS
http://www.ebay.com/itm/MAGNETEK-GPD...-/291581988070
If it says GDP on the face anywhere..its likely to be the same
drive..different badging
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus