wrote in message
...
I'm about to begin a simple project for cutting thin stock into
strips.

I need to machine the following:

A) Disks that will be the diameter of slitting saws but thicker and
without teeth but instead have relatively sharp edges for scoring.

B) Spacers about half the size of the above mentioned disks. (I'll
grind them to the necessary thickness).

C) An "Arbor", actually a one foot rod with a long flat that the
above disks, separated by the spacers, will fit on.

D) A three part table that will be comprised of two ends sitting at
opposite ends and on top of the bed.(There will be an "cover" to
hold the stock down to the bed).

E) Racks and gears for the bed ends and rod respectively.

The goal of this contraption is to allow me to score the metal stock
so I can break off the strips. (It would be like using a rolling
pin).\

I'm finishing up the exact dimensions and I'd appreciate some advice
on the specific metals I should use for the parts.

Thanks.

Darren Harris
Staten Island, New York.

Here's the mechanism. You supply the cutting wheels:
http://www.amazon.com/Rolling-Mill-J.../dp/B000RB5CXC