On 14/04/2016 09:17, Syd Rumpo wrote:
On 14/04/2016 08:57, bm wrote:
"Andy Burns" wrote in message
...
bm wrote:

Looking at this -
http://www.lonniesinc.com/images/Too...strom_7890.jpg

I begin to wonder how the devil they're made.

Assuming you're using an LCD screen, if you look at such an angle
that the
contrast is about to reverse, you can see the rivet through the halves
that's been ground flat ...

I mean how do they assemble the 2 pieces before riveting.


My guess is that the 'top' handle is put on to the 'bottom' jaw after
joint assembly.

Is the handle on the lower half solid? Doesn't need to be for strength,
and if not, could slide the other bit down a gap.