replying to Tony Hwang, Bobbo wrote:
dragon40 wrote:

Hi,
Spline and roller has to be proper size for the job. There is heavy duty
screen material(fiberglass) which is good for small dogs/cats which I
use on my screen door.


OK if you are doing a pool screen most likely you're using flat spline.
Starting at the top, position screen and hold in place with a couple
pieces of tape. You need a spline tool to set the spline. Using the flat
end, not the grooved end, roll the screen gently into the channel. Take
the spline, rounded edge facing inwards into the channel and using a
screwdriver set the very end of the spline until it holds. Now place six
inches or so of spline into the channel at the lower edge leaving the
upper edge sticking out. Using the grooved end of spine tool now, roll
along spline exposed at upper edge until it seats into the channel. Be
careful to not cut the screen at the lower edge with tool. Repeat for
sides and then bottom last. Done!

--