DIYbanter - View Single Post - 15mm pipe 1/2" BSP tap conector won't fit Grohe tap

Roger Mills[_2_]

On 06/02/2016 11:18, wrote:

The flexis presumably uses flat rubber washers? I suppose you could
grind off the spigots on the on the rigid connectors, and use rubber
washers.

Yes - flat rubber washers in the flexis.

And yes, I could probably reduce the spigots in the copper rigid connectors in seconds down below the thickness of the washers - if it were not for them being tight under the washbasin and inaccessible.

Flexis it will be I think.

Well, you'd have to cut off the existing pipes in order to fit flexis.
So why not cut them off, remove the spigots, and then put them back -
taking the opportunity to re-join them with service valves if you don't
already have any?
--
Cheers,
Roger
____________
Please reply to Newsgroup. Whilst email address is valid, it is seldom
checked.