On Sun, 17 Jan 2016 16:26:02 -0500, wrote:

On Sun, 17 Jan 2016 02:45:43 -0800, Gunner Asch
wrote:

On Sat, 16 Jan 2016 10:03:28 -0600, "Lloyd E. Sponenburgh"
lloydspinsidemindspring.com wrote:

fired this volley in
:

all 1 3/8" deep.


How do you figure to get a 1-3/8" deep slot from a cutter that only has a
5/8" cutting depth?

If you take the cuts in shallow increments, AND you don't have any play
in your spindle, you should be able to get within a half-thou. of the
cutter diameter, or so.

But not that depth!

L

Will take very..very..very careful setup and repeated cuts.

Or simply find a used horizontal mill...OR a used shaper. Problem
solved

Gunner
Pretty difficuld to do with a shaper to get a clean cut at the base
of the cut (end of the slot) unless cutting across the stock (1 inch
cut) and then to cut 3/16" wide and 1 3/6" deep would be some fun - -
- -

Very simple to do. One simply needs a sawhorse to put the end of the
work if its over table size