On Sat, 16 Jan 2016 10:03:28 -0600, "Lloyd E. Sponenburgh"
lloydspinsidemindspring.com wrote:

fired this volley in
:

all 1 3/8" deep.


How do you figure to get a 1-3/8" deep slot from a cutter that only has a
5/8" cutting depth?

If you take the cuts in shallow increments, AND you don't have any play
in your spindle, you should be able to get within a half-thou. of the
cutter diameter, or so.

But not that depth!

L

Will take very..very..very careful setup and repeated cuts.

Or simply find a used horizontal mill...OR a used shaper. Problem
solved

Gunner