On Sun, 17 Jan 2016 00:48:23 -0000, "Gareth Magennis"
wrote:

Er, no, because it is not possible to solder these switches, or even mount
them, to the conductive pads on the PCB.

They don't need a low resistance connection. Just a connection. You
can probably glue them in place with some hot melt glue. Or, if you
want something better, solder tiny squares of sheet copper to the
switch legs, and glue that in place. If you like spending your
customers money, try some conductive graphite flake or silver "paint"
and bury that under a layer of hot melt glue.

I am still in favour of a 16-way keypad glued to the synths top panel, with
flying leads/ribbon cable (hidden beneath such keypad) attached directly to
the keyscan ports.

Common decency, aesthetics, and my moral obligation to clean living
prevent me from offering an opinion of that idea. Sure, it will work,
but will be seriously ugly and messy. It's ok to fix something but
when you're done, it has to look good. Perception is everything,
which begs the question of whether the customer is going to pay for a
hacked keypad fix.

--
Jeff Liebermann
150 Felker St #D http://www.LearnByDestroying.com
Santa Cruz CA 95060 http://802.11junk.com
Skype: JeffLiebermann AE6KS 831-336-2558

---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus