well, what I meant was, there isnt any arching in the spark gaps. the
arching is inside the tube socket. at first, i sen the arching between the 2
focus leads.

If i pull out BOTH leads, and leave them apart from each other, then when i
try to power it up, it will arch in the tube socket again, but this time
somewhere else between 2 or so pin connectors.



"Sam Goldwasser" wrote in message
...
If you are getting arcing at the spark gaps with the tube socket pulled,
it may also be a short in the flyback causing the focus voltage to be
excessive, but not necessarily the HV.

--- sam | Sci.Electronics.Repair FAQ Home Page: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Site Info: http://www.repairfaq.org/REPAIR/F_mirror.html

Important: The email address in this message header may no longer work.
To
contact me, please use the Feedback Form at repairfaq.org. Thanks.


"Mike" writes:

I have this monitor, and when you power it on, it will degauss.

The HV will kick up, and a loud snap is heard and it is shut down. the
HV
sounded kinda strong in the first place.

after close examination, it was arching in the tube socked. I pulled the
tube socket and tried it again. and i could see the internal spark
between
where the 2 focus leads go into the socket. I pull one of them and tried
again, this time I seen an arc with the same magnitude somewhere else in
the
tube socket.

Sounds as if the HV is going exessive and shutting down.

In other words, im guessing the safty hold-down capacitors.

Any ideas?