View Single Post
  #14   Report Post  
Posted to alt.home.repair
micky micky is offline
external usenet poster
 
Posts: 8,582
Default leaking oil into the tub?

In alt.home.repair, on Sun, 04 Oct 2015 12:02:59 -0500, Vic Smith
wrote:

On Sun, 04 Oct 2015 14:44:01 +0000, Kathy
m wrote:

10 year old Moffat Washing Machine- has been no problem until it started
leaving a 'dirty' ring around the top of the tub. Have also noticed a few
small spots on clothes. It's definitely oil. Is this the transmission ( as
I have read it could be)? Is it worth a repairman's visit or should I go
straight to purchasing new?


Are they lying? Doubt it. But they say "highly improbable."

http://www.moffatappliances.ca/faq/faq2.jsp#6
"6. I am getting oil on my clothes/floor.
To minimize the possibility of electric shock, unplug this appliance
from the power supply before attempting any maintenance or cleaning.
Greasy or oily stains on clothes:
• The 1995 and newer washer transmission design makes it highly
improbable for oil from the transmission to get into washer and
splatter on clothing. Most of the time it is caused by splatters from
cooking oil. Stains from foods or cooking oils, sometimes called
"invisible stains", may not be noticed as you put clothes in the
washer. If not completely removed in the wash cycle, the oily spots
may pick up dirt from wash water making the spots visible. The washer
does not cause these spots.


Very interesting. Definitely worth cleaning the oily ring off and
running another load with different items.

Should never assume the worst about almost anything without retesting.

To prevent:
Wash garments as soon as practical after wearing, using more
detergent than normal and the hottest wash water fabric can stand.

To correct:
Rub in undiluted detergent, let stand 30 minutes and rewash, using
hottest water fabric can stand.

• If your water is extremely hot, 150 degrees or higher, the water
inlet hose(s) could start to break down, causing black greasy stains
on clothes. Refer to the Use and Care Guide for your water heater, set
the temperature accordingly, and replace the inlet hose(s). "