On 9/25/2015 4:54 PM, Electric Comet wrote:
On Fri, 25 Sep 2015 15:54:06 -0500
Leon lcb11211@swbelldotnet wrote:

That would be very boring. Remove two 1.5" long screws, remove the
cap and lift the speed control off, disconnect the three electrical
push pull connectors. There would almost be more to see watching me
move router from the router table to the work bench. ;~)

are tear-downs not boring
has that stopped anyone from watching them
they get an amazing number of views

Yeah, I'm not one that wants to get into that. Too much time to invest
and equipment.



the entertainment factor was not the reason
the reason is that more eyes get to have a look

I considered that but once the top cap was off it was surprisingly
clean inside. Just a touch of dust. The speed control module is a
housed circuit board and heat sink with a dark resin sealing it all
in.

if it is potted than there is not much to do

I'm guessing it is potted...



NO! Where did you see one???? ;~)

the festool of soldering irons is the metcal
they also are very quiet

Oh... ;~)



you oughta do videos
based on all your contributions here you would probably have lots to say
probably easily get festool and sawstop to sponsor your channel

Yeah that would be another job. I wold rather be building things rather
than "possibly" having a lot of people watching me pretty much build
nothing. There are a lot of well done videos of equipment that has
hardly been used. I'm not that guy.