Thread
:
Sanford Surface Grinder
View Single Post
#
22
Posted to rec.crafts.metalworking
DoN. Nichols[_2_]
external usenet poster
Posts: 2,584
Sanford Surface Grinder
On 2015-09-16,
wrote:
O.K. I remember that -- and I thought at the time that you were
trying to figure out how to mount a motor to your own machine, not
collect information about all of them. (Or did the collecting
information come later?)
You weren't posting the photos for me, DoN. I just came across them
later. Hope he figured out a mount, although on the Sanford it isn't
just a motor mount, it is a precision ground part of the spindle
carrier.
O.K. I never had mine off, so I did not know this. Thanks.
I don't have a month for the introduction of the machines. By the way,
the serial number is on a plate on the lower front of the machine, right
under the cross feed handwheel.
O.K. Found. I and to use some ScotchBrite to make the numbers
readable. It comes out as:
"SG 151 1471".
Really heavy to tilt it back when it is bolted to a base
platform which extends a bit beyond the motor, and only one arm is
working fully. :-)
Thanks,
DoN.
--
Remove oil spill source from e-mail
Email: | (KV4PH) Voice (all times): (703) 938-4564
(too) near Washington D.C. |
http://www.d-and-d.com/dnichols/DoN.html
--- Black Holes are where God is dividing by zero ---
Reply With Quote
DoN. Nichols[_2_]
View Public Profile
Find all posts by DoN. Nichols[_2_]