On Tue, 15 Sep 2015 21:29:37 +0100, ARW wrote:
"Charles Hope" wrote in message
...
In article , Tough Guy no. 1265
wrote:
On Mon, 14 Sep 2015 21:13:02 +0100, ARW
wrote:
"Tough Guy no. 1265" wrote in message
news
On Mon, 14 Sep 2015 20:19:12 +0100, ARW
wrote:
"Tough Guy no. 1265" wrote in message
news
Why would you assume they were on the same circuit?
On a installation that meets the IET regs than I would expect them to
be on the same circuit.
However I assume nothing as I have seen some right bodge jobs (and
not just from DIYers).
Assuming someone else has done something a particular way is stupid,
which is why you don't. So you've just answered your own question.
It's not dangerous to have two circuits, as people like you check.
You cannot always tell if two circuits are/may be connected together
via bad workmanship unless you have stripped the house apart to check
every last electrical connection.
The best solution is just to wire the job up correctly in the first
place.
As I've already said three times, you walk in front of both PIRs and make
sure neither make the wiring live.
I have a PIR I walk in front of and the light dosn't activate. Is that a
faulty PIR or a faulty lamp or something else?
The daft apprentice says it is because the sun is shining:-)
Took him 2 hours to work it out.
Only a problem if you take so long to rewire the lights that it gets dark. Anyway, you'd hear the PIR clicking or something. For some reason most still click even though they are disabled due to light levels.
--
Some "chinese english" instructions (with software for a camera card). This is the contents of a file named "English installs the elucidation.doc", quoted in its entirety:
The high regard's customer:
How are you!
Thank youing can use the pico product of my company, and please press below the operation order install, and thank!
A,The software installs in proper order
1, install the good WIN2000 system;
2, open the software light the dish;
3, double click the SETUP.EXE
4, the model number of the choice gearing
a)PICO2000_104( PALApplication) this model number can at most support 4 roads see the frequency signal the importation
b)PICO2000_208( PALApplication) this model number can at most support 8 roads see the frequency signal the importation
c)PICO2000_416( PALApplication) this model number can at most support 16 roads see the frequency signal the importation
5, after finishing installing, three documents that light patch in the dish the catalogue descend: The msdxm.ocx, odbc32.dll, odbcint.dll beat arrives the c:\ windows\ system inside.
6, square version of usage hero , please double click the light the English Pack in the dish the document.
7, the copy resemble the regulating of appearance tone must install the VideoSetup software to proceed to regulate, install the procedure under the light dish root the catalogue VideoSetup the blank page clip setup.exe.
Plank card gearing
1.Insert the plank card arrive the main plank PCI the slot;
2.Start the calculator, and the auto install the plank card the drive to move the procedure( position:Light dish driver catalogue bottom)
Change the compression method
Beginning the ? circulate the ? the importation the " REGEDIT", and make sure the ?? enter the registration watch the editor, and open the HKEY ? CURRENT ? the USER\ software\ univision Canada Linited\ the pico2000 double click the " CODEC" can is worth this key to change to" MP42" or" IV50"
Note:
MP42 the MPEG4 compress the way (suggestion adoption MPEG4 compress way, should compress the way the compression the rate to is high)
IV50 the INDEO compress the way