Thanks for the helpful tips!
It ended up being the convergence amps. When I reassembled the unit, I
forgot a plug. **DOH!!** The set works great now!!
Brad
"David" wrote in message
om ...
The set is in protect shutdown and you need to take special precautions
prior to attempting the troubleshooting of the failure.
Things I have seen cause this failu
1. Corrupted eeprom data. ******
2. lock up on clock or data lines, especially in the tuner.
3. blown audio output ic
4. failure on the dpc circuit board, increased resistor value or pin
circuit problem. ****
5. convergence output failure *****
6. digital convergence module failure, for those with it, also d/a
converter failure on those without the full module
7. shorted yoke windings ******
8. arcing high voltage cap ******
9. high voltage splitter
10. failed picture tube, shorted ****
11. vertical output ic failure *****
12. high voltage regulator op-amp
13. switch mode power supply regulation failure
14. flyback
The ones with the extra stars are the failures I see more often than the
others.
David

"Fishhead" wrote in message
...
Toshiba RPTV Dead. Power Light Blinks But Set Won'T Fully Power Up.The
set
acts like its going to powerup, then clicks off.Replaced convergence
amps
(Stk392-110). No help. I did find a possible open winding in T862.Any
other
ideas??Thank for any