"Paul Landregan" writes:
are you linking the green wire to ground to activate the PSU? You have
marked it PS-ON?
On my supply this allows me to run anything outside the case.
But do make sure there is an adequate load on the +5 V - an amp or so
should do it (e.g., 5 ohm, 5 W resistor).
--- sam | Sci.Electronics.Repair FAQ Home Page:
http://www.repairfaq.org/
Repair | Main Table of Contents:
http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ:
http://www.repairfaq.org/sam/lasersam.htm
| Mirror Site Info:
http://www.repairfaq.org/REPAIR/F_mirror.html
Important: The email address in this message header may no longer work. To
contact me, please use the Feedback Form at repairfaq.org. Thanks.