If you are very sure that you ESR checked, and replaced ALL the bad
caps, then the only thing you have left are some base components, and
the deflection yoke.

The caps you missed are the bad ones... I am convinced that you still
have a bad cap in this one, or the deflection yoke is defective. In
some sets, there are some small caps, and or thermo resistors in the
deflection yoke for compensation. This may not be the case for this
set, but it is a thought. I have had resistors go sort of opened in the
deflection circuits causing this type of fault as well.

But... I am still sort of convinced by your description, and by past
experience there is a cap or two that you missed!

--

Greetings,

Jerry Greenberg GLG Technologies GLG
==============================================
WebPage http://www.zoom-one.com
Electronics http://www.zoom-one.com/electron.htm
Instruments http://www.zoom-one.com/glgtech.htm
==============================================
"Chuck" wrote in message
...







Hi all. I inherited this set from a tv repairman who
was closing up shop. He couldn't repair it so I
decided to give it a go. The picture has vertical
fold over at the top and is pulled up from the bottom.
I've replaced all the electrolytic caps in the
vertical circuit and the jungle, eeprom , and vertical
output ics. Other capacitors in the vertical circuit
have been subbed. Resistors have been checked in
circuit and appear to be within tolerance. Adjusting
the vertical parameters in the service menu doesn't
change the symptoms. The capacitors in the pincushion
circuit that can affect vertical height have been
subbed. If anyone has ever seen such a problem with
this chassis, I'd appreciate their assistance.
Thanks. Chuck