In sci.electronics.misc Watson A.Name - 'Watt Sun' wrote:
I got tired of switching the leads of my DMM. Suddenly if dawned on
me that I can just set the power supply to 10.0V for exaample, and
read the current, and then divide the voltage by the current to find
the resistance. Like I put a resistance on the PS, it reads 10.0V and
the current is .018A, so 10 / .018 gives 555.6 ohms. Must be a 560
ohm resistor.

I turned my PS into an ohmmeter - FREE!

Hee-hee - Work smarter, not harder!

Of course, make sure the current stays low so the resistance doesn't
overheat. For low resistances use a volt or less.

This isn't especially usefull usually.
However, with low ohm resistors, it can be.

Given a constant current of an amp, the $5 meters mentioned elsewhere
can now measure with a resolution of .1mohm.


--
http://inquisitor.i.am/ | | Ian Stirling.
---------------------------+-------------------------+--------------------------
My inner child can beat up your inner child. - Alex Greenbank