On Mon, 21 Jul 2003 05:46:57 +0100, "The Question Asker"
wrote:

I have replaced ith a new mixer tap so its is a bit hard to connect a hose
pipe between them..

Depending on the innards of the mixer tap, the water could be mixed at
the spout outlet or in the body.
If it is mixed in the body, putting your thumb over the end and
turning both on will have the same effect.
If it as mixed at the outlet, you might be able to clamp a short piece
of blocked off pipe or similar over the outlet. This will also link
the hot and cold.


--
John