Drill attachment in place of chuck?
Look for a screw of some sort in the throat of the chuck.
Might be there and if there - take it out and then you can
extract the chuck off the arbor.
Martin
On 5/8/2015 1:25 PM, woodchucker wrote:
On 5/7/2015 4:38 PM, Electric Comet wrote:
On Thu, 7 May 2015 19:49:17 +0000 (UTC)
John McCoy wrote:
I beleive chucks come one of two ways - either all one piece
("integral arbor") or with a Jacobs taper.
this looks like it's two pieces
if it is two is it possible to separate them
So there is the mt taper for going into the spindle,
and then they is usually but not always a J taper or sometimes other
tape for the MT arbor to the chuck.
There are wedges used to pop them apart. You can buy the reasonably.
They are meant to remove the part w/o destroying the chuck. The
pressure is put on the landing around the abor, not on the moveable ring
that tightens the chuck.
I think they can be had for around $16 ..
|