On 3/24/2015 7:49 PM, Lew Hodgett wrote:
"Gramps' shop" wrote:


I'm using a v-bit to cut around my template. Clockwise, correct?
-----------------------------------------
Depends.

When possible you want to avoid a climb cut which
usually means COUNTER CLOCKWISE around the template,
but not always.

Lew


Assuming you're on the outside of the template, rather than on the
inside of a template with a hole in it.

---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com