On 23-Mar-15 10:39 PM, Larry Jaques wrote:
On Mon, 23 Mar 2015 14:16:40 +0800, Bogus wrote:

On 22-Mar-15 11:10 PM, Bob Engelhardt wrote:
On 3/22/2015 8:24 AM, Bogus wrote:
...
The Loctite option is interesting, certainly simple. There may be
stronger grades available too. I'll have to do some measuring, the fit
at the moment is a sliding fit, no press or interference at all.

The Loctite 609, for example, is good for up to .005 sliding fit. That's
pretty loose. Strength is well above your needs.



Thanks Bob, it's not an expensive exercise just to grab some and test it
out either. 0.005" is quite a bit.

Got a hammer, punch, and anvil? g It won't take much to close up
the gap by putting a small flat on the shaft.

--

Shhhh! I've done that too.