On 12/22/2014 7:38 PM, -MIKE- wrote:
On 12/22/14 7:15 PM, Leon wrote:
On 12/22/2014 5:50 PM, -MIKE- wrote:
The subject was brought up recently, so I thought I'd show how I do it.
You have a drilled hole that is too small. You can't just put a bigger
sized Forstner or spade bit it the hole because it has nowhere to
center. Here's the solution!

http://youtu.be/DeKCCsgX-II


Step Drill.

But you can drill a hole bigger with a true Forstner bit.


'splain, por favor.
Go a picture?




A true and well made forstner bit is capable of cutting a cove/scallop
out of the edge of a board. It does not use a center point to guide it,
the edges guide it.