-MIKE- wrote:
The subject was brought up recently, so I thought I'd show how I do it.
You have a drilled hole that is too small. You can't just put a bigger
sized Forstner or spade bit it the hole because it has nowhere to
center. Here's the solution!

http://youtu.be/DeKCCsgX-II


Take a correct size forstner bit and drill a hole in a 3/8 or 1/2"
piece of scrap. Center this hole over the original smaller hole and
clamp in place. Using this as a guide drill out the smaller hole with
the forstner bit.

This is for when you have forstner bits but no Harbor Freight within
30 miles (as I am).

--
 GW Ross 

 You have two choices for dinner: Take 
 it or Leave it.