Leo Lichtman wrote:

"AHilton" wrote: Make a morse taper on the opposite
side of the wood from your cone section and stick that into the morse taper
in your tailstock.(clip)
^^^^^^^^^
Is it Terry's intention to have the tube spinning in the lathe? That would
require a live center type support for the tailstock cone. I can picture
the smoke coming from the above setup. :-)


Use a Jacobs chuck with the original hole and rod.
Just wax the rod and put a washer between the Jacobs Chuck and the cone.
Should get by at slow speeds. I don't think the morse taper is a good idea.

--

Gerald Ross, Cochran, GA
To reply add the numerals "13" before the "at"
............................................
Never use a preposition to end a
sentence with.




-----= Posted via Newsfeeds.Com, Uncensored Usenet News =-----
http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
-----== Over 100,000 Newsgroups - 19 Different Servers! =-----