In article ,
Jon Connell writes:
Our house has a raised patio - a tall one at 900mm - built onto the back
of the house. You can more or less see it he

http://li.zoocdn.com/26c88c6143f7f50..._645_430.j pg

There is a limited damp problem inside the house as you'd expect from
bridging the damp course like this.

I'd like to functionally retain and extend the patio, so I am thinking
about replacing most of it and building a new block wall with an air gap
between the patio and the house. Am I going to run into problems if I
bridge the gap at the top of the wall with paving?

Yes. Resolution isn't good enough to be sure, but it looks like you
have flemish bond 9" brick walls. The splash-back from rain hitting
the patio and splashing onto the wall will probably be enough by
itself to keep the wall damp, even if you have no penetrating damp
from below the patio surface.

If you are cutting away the patio from the house during the rebuild,
I would tank the outside of the wall from below the damp course to
the top of the patio with a damp-proof membrane to prevent damp
penetration below the surface, and then have an 18" waterproof render
skirt applied along the patio to protect the wall from splash-back.
Also, make sure the patio slopes slightly away from the house, so
there is no puddle forming along the join.
Another option to protect from splashback is a French drain - a
waterproof channel about 12" wide between the patio and wall which
is filled with pea shingle - the rain won't bounce off this.

The other thing I would be slightly concerned about is 900mm of
soil or rubble being retained by the house wall which might not have
been built as a retaining wall in the first place. Is there 900mm
of nothing on the inside at that point, or is the inside ground level
higher than the original outside ground level?

--
Andrew Gabriel
[email address is not usable -- followup in the newsgroup]