We have an old Bridgeport Interact with a Heidenhain TNC 151 Controller.
It has not been run in a few years. I wanted to do a canned cycle today
but it will not finish the boot cycle. It finishes the memory test then
show power interrupt. So I push the CE and the Pass over z - reference
mark, Pass over y - reference mark, Pass over x - reference mark, axes
show up on the screen and this is were I am hung up. I can not do anything
from here. Any idea? Thank you so much

Mike B

--
posted from
http://www.polytechforum.com/metalwo...id-602952-.htm
using PolytechForum's Web, RSS and Social Media Interface to
rec.crafts.metalworking and other engineering groups