Julie Bove wrote:

"philo " wrote in message
...
On 09/04/2014 02:02 AM, Julie Bove wrote:
Oh so annoying! I had called the plumber because it was getting to
where our replacement water heater had to be lit once a day. Initially
we had a new one installed on New Year's Eve, 2009. It worked for a
while but then I had to keep relighting it. At first it was perhaps
every three months, then every week then like every half an hour.

They never could find out what was wrong with it. They replaced every
part they could and finally just gave us a new one. And it was fine at
first. But the same problems started happening up until now! I just
relight it perhaps 2 hours ago when daughter took a shower and ran out
of hot water. I had gotten to the point of being OCD in checking it to
make sure it was still lit. And it had been the last time I looked.
And even though it is a 50 gallon tank, apparently when it goes out, the
water cools very quickly.

So I relit it, called the plumber because it was getting to where I had
to light it daily. Plumber asked me some questions about it and I had
to go out there to look at it. And it it wasn't lit! So it went out
less than 20 minutes after I lit it. And now it won't light at all.
Grrr... Grrr... Grrr...

I am sick of this. And they can't do anything about it tonight. Guy
said he could come out here but I would have to pay $150 just to get him
out as it would be after hours charges. But he had no clue whether or
not he could do anything about it tonight. So... We wait.

Only thing I can figure is that it might be the venting. That is the
only thing they didn't check. They did say that the last one wasn't
drafting properly or something like that.
X




(Snip
if it was not drafting properly, then it was senseless to attempt a
repair or replacement...the venting must be fixed!

The venting was either done wrong or your chimney may be plugged.

I have no clue and apparently neither do they. It did work for a while.
Now it simply will not light at all. I did try again twice.
Hi,
For now light a candle and stick it in the burner chamber, does it stay
lit? If so, gas sup[ply is OK?
Venting or gas supply, what else could be the trouble?
How is the venting done? Tied into furnace stack or all by itself?
Often we tend to over look most simple basic things experts do that all
the time too wasting time.
What kinda chimney?