On 2014-08-18, wrote:
Thanks for the tips so far.

I goofed and didn't make it clear that the part I need is the lantern
type tool post itself, not the took holder (which I have a few of around
here.

The link to the Cincinnati parts manual was very helpful. My problem
now is that there is no relief on the backside of the clapper for the
flange on the tail of the lantern type tool post. So I don't understand
what would keep it from pulling out of the hole when the bolt that holds
the tool or tool holder in place is tightened up.

How much room is there in the box under the clapper plate? if
there is enough, you don't need the step in the hole.

Now I am wondering if maybe there is a relief cut into the head itself
to provide clearance for the lantern tool post's flange.

Check the cavity under the clapper plate in the clapper box.

Enjoy,
DoN.

--
Remove oil spill source from e-mail
Email: | (KV4PH) Voice (all times): (703) 938-4564
(too) near Washington D.C. | http://www.d-and-d.com/dnichols/DoN.html
--- Black Holes are where God is dividing by zero ---