On Sun, 10 Aug 2014 21:50:33 -0700, pyotr filipivich
wrote:
Gunner Asch on Sun, 10 Aug 2014 17:25:16 -0700
typed in rec.crafts.metalworking the following:
On Sat, 09 Aug 2014 20:12:10 -0700, Jon Danniken
wrote:
On 08/09/2014 03:28 PM, Howard Beal wrote:
I like them. They appear to be safer than the typical
jack stands. Seems like they would be easy to make
using square steel tubing. Any ideas for improvements?
https://www.youtube.com/watch?v=cXCvq6DNJi0
I've never had a problem using jack stands under the frame, and I would
never trust anything that used the wheel to support a vehicle I was
planning on getting underneath.
That having been said, the stands in the video are pretty cool looking,
but I'd still rather stick to jack stands underneath the frame.
Jon
Im with Jon.
Ive got 8 jack stands that get regular use and 3 sets of drive up
ramps that are also used regularly.
Course..no concrete floors here. Just hardpan or asphalt (uneven
asphalt)
I had an ... experience, many years ago, in Germany ... with jack
stands/ Raising a bus to get at the rear wheels. Jack up the right
side, insert jack stand. Crawl under left side, sit up, insert jack,
start pumping. I hear this little tiny "creak". Lay back down and
roll out from under. Sit up next to a bus 'bouncing' on the springs.
What can I say, I was younger, skinnier, and a bit faster in those
days.
Seems that a jack stand can concentrate the whole weight of a bus
on one single cobble stone. Which is basically setting on 'dirt'. So
the dirt compacted under the weight, just enough to tip the jack stand
past "too far".
So, if working on gravel, or other unsolid surface: put down at
least a piece of _flat_ wood with will hold all the feet of the jack
stand, and then some.
Still no guarantee the thing won't tip over, but I have not have
that problem since.
--
pyotr filipivich
"With Age comes Wisdom. Although more often, Age travels alone."
Had one slowly sink into the ground one winter. Took about 30
minutes..but when I came back to that side..the brake drum was sitting
on the ground. and the only sight of the stand was the post sticking
out of the dirt.. Now I use diamond plate or 2x12s if I am working in
some place I dont trust, under them. Fortunately..around here..it
takes a lot of water to bust up the clay and we havent had but 4" of
rain in the past 18 months.
--
"Living in the United States now is like being a Tampon.
We're in a great place, just at a bad time."